The XMK-010 is designed for flush mounting in a 71x29mm cutout.
The controller features self-diagnostic capabilities to ensure safety. Symptom/Error Code Possible Cause No voltage or faulty wiring Check 220V power connection. Display shows "EEE" or "---" Sensor error: Short circuit or open circuit Check NTC sensor connections. Replace sensor if necessary. Compressor won't start Compressor delay active xmk-010 manual
Disclaimer: Ensure the main power is disconnected before installing or wiring the XMK-010 to prevent electrical shock. The XMK-010 is designed for flush mounting in
Note: In refrigeration mode, setting a compressor delay (e.g., 3-5 minutes) is recommended to prevent rapid cycling. 4. Operational Modes: Heating vs. Cooling The XMK-010 can be configured for one of two modes: Display shows "EEE" or "---" Sensor error: Short
Use the or Down arrows to set the desired target temperature (Set Value). Press Set again to save the value. 3.2. Entering Advanced Settings (Differential/Delay)
The XMK-010 is an intelligent thermostat that acts as a single-chip microcomputer to measure temperature and control equipment operation. It is often sold as a "Double Limit" controller, allowing users to set both high and low thresholds to turn connected devices (like compressors or heaters) on or off. Key Features