S-tec 55x Installation Manual | RELIABLE ✯ |

Use the correct tension specified in the S-TEC airframe-specific kit.

Ground shields at the programmer end only to prevent ground loops. Circuit Protection: Use a dedicated 5-amp circuit breaker. S-tec 55x Installation Manual

Check that servos do not hit their internal stops before the flight controls hit their external stops. Use the correct tension specified in the S-TEC

Perform a standard pitot-static leak test after plumbing the transducer. perform these tests:

Verify your specific aircraft tail number is on the Approved Model List (AML).

Confirm you can manually overpower the servos with reasonable force.

Mount the pressure transducer on a rigid surface to prevent signal "noise." 🧪 Post-Installation Ground Checks Once the hardware is secure, perform these tests: