Quicksurface Crack |link|

: If the fitting tolerance is set too tight, the algorithm may struggle to bridge the gap between irregular mesh points, leading to "tears" in the generated surface.

Ensure that the "G0" (Position) and "G1" (Tangency) constraints are active on shared edges. quicksurface crack

If you are seeing a specific error message or a visual "rip" in your model, let me know: Are you using or Manual Surfacing ? What is the file format of your original scan? Is the crack appearing on a sharp edge or a smooth curve ? : If the fitting tolerance is set too

If the surface is cracking because it’s trying to follow the scan too closely: Increase the . What is the file format of your original scan

Smooth out high-noise areas that might cause the surface to "jitter" and crack. 2. Adjust Fitting Tolerances