After modifying values with the arrows, you must press SET for at least 3 seconds to definitively save the new settings. If no button is pressed for 60 seconds, the device will exit without saving (timeout). Installation manual - Tempatron
Supports standard Carel NTC (10 kΩ at 25 °C) and PTC (985 Ω at 25 °C) probes. carel ritcusrg02 manual
Avoid installing probe cables near contactors or circuit breakers. If extension is needed, use cables with a minimum cross-section of 0.5 mm² . After modifying values with the arrows, you must
If the compressor or fan icons are blinking, it typically indicates a delay (e.g., minimum off-time) is active before the device will start. 4. Programming Parameters After modifying values with the arrows